14 Repairs and maintenance
14.1 Repairs
Repairs are subject to inspection and must be carried out at Minebea Intec.
In case of defect or malfunction, please contact your local Minebea Intec dealer or service
center for repair.
When returning the device for repair, please include a precise and complete description of
the problem.
14.1.1
Battery for date/time
The lithium battery (5) for backing up the calendar/time chip is located beside the power
supply on the main board (under the cover; see Chapter
).
The lithium battery for backing up the calendar/time chip is located on the main board.
The battery is activated before the device leaves the factory.
Note:
After initial start-up, the date and time must be checked and set if necessary under
- [Date&Time].
14.1.2
Changing the battery for date/time
The device is equipped with a lithium battery for backing up the time/calendar chip. If the
voltage drops below the specified minimum, or in case of defect, the battery must be
replaced by Minebea Intec customer service or by an equivalent trained technician.
The battery is activated by setting the date and time under
- [Date&Time].
For disposal information, see Chapter
For battery lifespan, see Chapter
14.2 Maintenance
Maintenance work may only be carried out by a trained technician with expert knowledge
of the hazards involved and the required precautions.
14.3 Soldering work
Soldering work on the device is neither required nor permitted.
14 Repairs and maintenance
X3 Process Indicator PR 5410
EN-321
Minebea Intec
