32
Procedures
Press the
key.
The load display will show “2000”, and the digit
of 10
0
will flash on and off.
In case that calibration has completed already,
the registered output value of load cell at that
time will be displayed.
B th
tti
f
i i
l
th di it
8
Set the actual load value going to apply on the
load cell with the right keys.
The load value applied on the load cell should be
By the setting of minimum scale, the digit
of minimum display that flashes on and off
will be as follows
：
The minimum scale
1,2,5
10
0
digit
The minimum scale
10
10
1
digit
key
：
Set value carry key
key
：
Set value inclement key
key
：
Set value initialization key
It can be increased continuously by the
continuity press of the key.
The load value applied on the load cell should be
less than the maximum display value set in the
step 6 and should be the maximum load that can
apply on the load cell with the range of (the
minimum scale
×
100)
〜
99 999 as well.
key
：
Set value initialization key
9
Press the
key.
The load display will show “ZERO”.
Here, set the initial load application.
