Common Troubleshooting
1. The model was detached from the platform and adhered to the release membrane
The leveling distance is too far.
The support didn't work well.
Bottom exposure time is short.
Normal Exposure time is incorrect.
The model is too small and the contact area is too small, so the bottom plate needs to be added
Because the model is too large and heavy, the support with large area at the bottom needs to be added
2. Leakage
The Fep Film is not tight
Damage of Fep Film
3. Print with stripes
The screw rod is not installed properly
Screw rod bending
The Build Plate is not tight
Model orientation is causing too much suction
4. Printing has leakage layer
Insufficient exposure time
The platform is not installed properly
Resin problem
5. There are holes in the print
The screen has dark places or dark spots, there are impurities or dust between the material trough and the screen, and there are
impurities on the release film.
6. Other issues:
Cannot turn on the machine
2K screen does not light up
Aging of 2K screen
USB Memory Stick does not work or cannot read files
Display screen, white screen, dead screen, flash screen, etc
UV lamp does not work
Motherboard breakdown
Power breakdown
16
