User Manual of DH-300/400 Full Automatic Soldering Robot
28
Task selection operation process:
X→ (The task number is increased by 1 for each press), X← (The task
number is decreased by 1 for each press)
Y↑ (The task number is increased by 10 for each press), Y↓ (The task
number is decreased by 10 for each press)
OK
Wait till the decimal point is displayed on LED
Display status of nixie tube:
Task selection is completed after OK button is
pressed
Task selection is completed
3.1.4 Running
This function realizes the welding startup of the confirmed tasks.
Operation process:
After task selection is completed, directly press “Run” button.
Display status of nixie tube:
The welding spots are counted in real time
during task execution, and it indicates that
300 operating points have been welded.
Task execution is completed, and the task
number is displayed again.
If the automatic delay operation function is set in the function setting,
when pressing “Run” once, the equipment will execute the automatic
