User Manual of DH-300/400 Full Automatic Soldering Robot
52
7.
200ºC-480ºC
Without sleep and
automatic shutdown
Note: In sleep and automatic shutdown mode, if the machine does not run
within 20 minutes, the power supply of the welding head will be reduced,
and will be displayed. In this state, the machine can sleep slightly.
When the temperature control system of the machine enters the sleep state,
the temperature of the welding head will drop to 200ºC (if the set operating
temperature is higher than or equal to 200ºC) or 50ºC (if the set operating
temperature is lower than 200ºC), and this temperature will be kept until
the temperature control system recovers operating. If the temperature
control system does not be waked up after entering the sleep state for 40
minutes, the power supply of the welding head will be automatically cut off,
and the window will have no display.
The factory settings of the temperature control box is “6.”, namely without
sleep and automatic shutdown mode.
Two wake-up methods of sleep:
1.
Turn off the power switch of the temperature control box, and then turn on
the power switch again;
2.
Press any key on the temperature control box.
3.3.4 Calibration of Soldering Iron Temperature
After the heating element or the soldering bit is replaced, the soldering iron
temperature shall be calibrated again. The calibration method is as follows:
1.
Set a temperature value of the temperature control system.
2.
When the temperature is stable, measure the welding tip temperature with
the soldering iron temperature tester, and record the reading value.
3.
Press and hold “SET” key, simultaneously press “▲” and “▼” keys, and
then the temperature control system will enter the temperature calibration
mode.
