User guide P9-0151-B
19 of 64
Version 3.0.4 - 2017
Medema A/S
Driving the Mini Crosser M1 Cabin
Getting in and out
It is important to learn a safe technique for getting in and out of
the Mini Crosser.
In general the following method should be followed:
• Make sure that the Mini Crosser M1 Cabin is off (switch turned to
0) when getting in and out, otherwise the Mini Crosser could start
if the accelerator was touched inadvertently.
• Make sure that the brake is on. (Lever for disengaging motor in
top position.)
• Put the steering column in vertical position.
• If necessary, raise the armrest.
Note! - Do NOT use the dors as support, when entering or get-
ting out of the vehicle.
For some users the assistance of an attendant can be re-
commended. The attendant should:
• Take care not to injure him/herself when lifting/lowering/supporting
the user.
• Make sure that the Mini Crosser is stable and unable to move.
Turn off the Mini Crosser and check that the brake is on.
• Make sure that the seat the user is being moved to is stable.
Turn the Mini Crosser off, return the
steering column to upright position and
raise the armrest.
IMPORTANT!
The Mini Crosser will turn itself
off automatically after it has
been stationary for 10 mi-
nutes even if the key has been
turned to driving position. The
battery indicator flashes with
6 lamps at a rate of about 3
seconds.
To restart the vehicle, the key
must be turned to stop po-
sition (0) and then to driving
position (1).
