User guide P9-0151-B
39 of 64
Version 3.0.4 - 2017
Medema A/S
Fuses
The Mini Crosser M1 Cabin has the following protection
systems:
• Automatic overload protection, which limits the current to the
motor. This protection is integral to the control system and cannot
be adjusted. It prevents both the control system and the motor
from being overloaded. In the event of overload the current to the
motor is reduced - full speed and traction can be resumed after
the motor has cooled down for 2-5 minutes.
• The control fuse protects against mains faults. It is located under
the rear cover.
• The main fuse protects against short-circuits in the main current
circuit. The fuses are located under the rear cover behind the bat-
teries. Fuse type DIN 2581.
• If the ignition key is turned at the same time as the accelerator is
operated, the vehicle will not move off for safety reasons.
• The lights and horn are protected by electronic fuses, which
protect against any short-circuiting that may occur. To prevent ac-
cidental short-circuiting when a bulb is changed, the Mini Crosser
must be turned off when the new bulb is fitted and then turned on
again afterwards.
Take the rear cover off. The plastic cover can be removed by squeezing the sides.
Now the fuses can be replaced.
