User guide P9-0151-B
49 of 64
Version 3.0.4 - 2017
Medema A/S
Lever for rotating the seat
The lever must be pulled back
to rotate the seat. The seat can
then be rotated to each side,
locking at each 45°.
The lever is spring-loaded, and the seat is locked automatically when
the lever is released. This lever is located on the right side as stan-
dard, but can also be positioned on the left side.
When the lever is located on the left-hand side, it must be pushed
forward in order to rotate the seat instead of pulling back.
Out / in adjustment of the
lever for rotating the seat
Lift the seat off the vehicle.
Loosen the two Allen screws
and the lever can now be ad-
justed out and in to the desi-
red position.
Placement of lever for rota-
ting the seat on the left-hand
side
Remove the two Allen keys and
pull the lever out.
Insert the lever from the left-hand
side and tighten the Allen screws.
When installing the lever on the
left-hand side, the lever must be
pushed forward to rotate the seat.
.
Mount the seat again
In order to ensure that the
seat returns to the correct po-
sition, the lever for rotating the
seat must be released in order
to place the seat.
Introduction to the Ergo2 seat
