|
27
|
1) Turn on the washer by pressing the Power
button (
①
).
2) Open the drum door.
Press the Door Release button (
②
) to open the drum door.
3) With the door open, place the laundry
inside the drum and then close the door
shut.
• Make sure to close the detergent and fabric-softener
drawers completely before proceeding.
※
Do not use detergent or fabric softener with Dry course.
※
Limit the load size to 1.5kg when using the Dry course.
※
Exceeding the recommended laundry-load size may
result in abnormal noise, abnormal vibration, and/or a
malfunction.
4) Use the Dry button (
③
) to configure the
settings.
• Use the Dry button to configure the settings.
※
Each press of the Dry button cycles through the settings
as follows:
AUTO → 30 (30 mins) → 59 (59 mins) → 90 (90 mins) →
2H (2 hrs) → 3H (3 hrs)
※
AUTO chooses the most suitable drying time based on
the weight of the load and displays the remaining time on
the LED display.
※
AUTO chooses from 59 mins, 120 mins, and 180 mins
based on the weight of the laundry load and starts drying
the laundry automatically.
※
AU is shown on the LED display.
5) Press the Start/Pause button (
④
).
The door will lock and the dry cycle will begin.
Dry
Use this course to dry everyday items like towels, socks, and dress shirts and regular laundry.
The course lasts for 59 minutes at 87 °C.
Tip
"If you wish to wash and dry your laundry in a single step, use the Wash
& Dry course."
Note:
- Do not use detergent or fabric softener.
- Pressing the Power button and then the Start/Pause button starts the wash cycle using the initial auto-selection settings.
- Refer to the drying capacity and limit the load size to less than 1.5kg.
- Keep the water valve open (a small amount of water is drawn and drained for improved drying performance).
-
is displayed on the LED display once the dry cycle is completed, and the door is unlocked once the temperature drops to a
certain level.
- The dried items may be hot. Be careful when taking them out of the washer.
- Some shrinking and/or deformation may occur depending on the fabric of the clothing (make sure the item is safe to dry using heat beforehand).
- The items are deliberately left slightly damp to prevent damage and wrinkling. If you are not satisfied with the residual dampness, dry the items
more.
- If there is too much water inside the drum, the washer will drain some of it for safety.
- Pressing the Start/Pause button during the dry cycle will show the FA message on the LED display and then the door will be released once the
temperature inside the drum drops to a safe level.
- Q: During the dry cycle, pressing the Start/Pause button doesn't stop the washer.
A: If the washer is paused or turned off during the dry cycle, the washer will continue to run its fan until its internal temperature drops to a safe
level in order to protect itself from damage. Once this cooling phase has ended, the drum door will open so that you can take out the laundry.
4
3
1
2
미니 combo_WGC-02M3GK07B,02M3GK07BDT(영)_DEFR.indd 27
2021-11-16 오후 1:21:54
