mini0806 X44, User Manual

SETTING

MOTION DETECTION

Motion detection is used to reduce the amount of storage space used. When 
there isn’t obvious motion detected the camera will switch standby. Once 
motion over the threshold value is detected, the camera will start recording 
and continue until 15 seconds after the motion stops. Here you can set the 
detection sensitivity.
options:    

OFF

                  LOW
                  MIDDLE
                  HIGH

LDWS DETECTION

The camera will warn when it detects a lane departure, including normal 
planned lane departures. Here you can define the speed threshold above 
which the LDWS will become active.
If you wish to use LDWS then it is recommended to use the HIGH SPEED 
setting so that it only operates on the highway, otherwise you may become 
desensitised to the warnings.
options:       

OFF

                  LOW SPEED

MIDDLE SPEED
HIGH SPEED

LDWS CALIBRATION

This adjusts the LDWS reference lines to improve the LDWS operation. Please 
use the UP and DOWN buttons to move the top line to the height of the horizon 
and the bottom line to the height of the front of your car. Use the OK button to 
confirm the adjustment of each line.

PARKING GUARD

When you have turned off your engine, the 0806 camera will detect the battery 
voltage change and launch Parking Guard mode. The video recording will then 
be low frame rate to save storage space. Once any impact over the threshold 
value is detected, the camera will change to normal recording mode to save a 
30 second video clip. This file will be protected from over-write by the loop 
recording function. 
(You need the Parking Guard mounting bracket to support the Parking Guard 
function, which is an optional accessory.) Here you can define the impact 
detection sensitivity.

aware that the maximum video file size is 4GB.
options:       1 MIN

3 MIN

5 MIN
OFF