MiniacRC
[ 50 ]
ELECTRONICS
Parts) 5 to 9 gram servos (x4), pushrod (0.85 to 1 mm music wire), control horns (x4)
Note: You may want to refer to a FliteTest build video online for exemplary demonstrations of
some of the steps involved in this section.
Cut out two slots by connecting the pair of dots on each side of the fuselage. Widen the slots,
string pushrods through them and hook each rod to a servo arm using z-bends.
Glue the servos into the square cavities on the fuselage, pressing the wings of the servos into
the relief cuts that were previously made.
Perform dry fits of the control horns into the tail surfaces and perform z-bends at the
appropriate points on the pushrods. Check for free linkage movement and glue the horns in.
Pass a long pushrod through the central cavity on the wing and out one of the servo cavities.