• In case of suspicion of any leak or dysfunction, put immediately the ON/OFF button of the MiniComp in the
« OFF » position
• When the MiniComp is working, the water pump must always be submerged
After the filling
• Open
slowly
the pressurized air circuit with the decompression valve (let the valve in open position)
• Disconnect the MiniDive Pro, Pro+, Carbon, or Carbon Max from the MiniComp, for that, pull the female clip
ring before eject the male clip from the DIN adapter
• Let the voltage applied a few minutes in order to let the water pump in working
• Change filters from the cartridge
• You could change the water of the container in order to make faster the cooling of the MiniComp. The water pump
must always be submerged
• If you will not re-use the MiniComp, unplug the compressor
WARNING
• To avoid any burn risks, do not touch the MiniComp except elements provided for that purpose
7. Dangers and security instructions
• Stop the functioning (OFF position) of the MiniComp every 15 minutes of continuous working (let the water pump in
working)
• After 15 minutes working, let the MiniComp cool during 10 minutes before re-use it
• In case of impact, the equipment may have been damaged without present any optical damage. In case of doubt
contact your dealer
•
If you do not change the filter, it can cause a deterioration of the quality of the pressurized air and affect the
health of the user
• It is totally forbidden to change the placement of the parts or to modify any feature of the MiniComp, except elements
provided for that purpose
• Do not integrate MiniDive’s elements on another diving equipment or inversely
• The MiniComp must not be in contact with water, except the water pump. Otherwise unplug the compressor and let it
dry during minimum 48 hours.
• Do not operate the compressor in a place where the air is polluted (next to another engine or mechanical device). Do
not use it near gases, oils and chemicals or in dusty or sandy areas.
8. Repairing
During repairing manipulations, the MiniComp must not be powered or pressurized, for that unplug the power cable and
unscrew the decompression valve.
8
Summary of Contents for MiniComp
Page 9: ...9...
