mi niDSP Ltd, Hong Kong /
/ Features and speci fi cations subject to change wi thout pri or noti ce
33
4
U
SING THE NANO
AVR
Once configured, the computer is not required to operate the nanoAVR. The front panel, an infrared remote, or
the miniDSP smartphone app can be used to control:
Preset selection
HDMI input selection
Master volume (remote control and smartphone app only)
Master mute (remote control and smartphone app only)
Note: changing the selected configuration preset from the front panel or remote control while the user interface
is connected will disconnect the user interface.
4.1
S
TATUS INDICATORS
The current status of the nanoAVR is indicated by a set of LEDs:
Preset
Indicates the currently selected configuration preset (1 through 4).
Input
Indicates the currently selected HDMI input (1 or 2).
M
Master mute is enabled.
D
Data communication between the user interface and the nanoAVR is active.
4.2
F
RONT PANEL CONTROLS
The nanoAVR uses a minimalist physical control design with a single control button.
To change the selected configuration preset
Briefly press the control button. The selection LED blinks quickly. Briefly press the button to
move to the next preset, and repeat until the desired preset LED is lit. Press and hold the control
button, and the LED will now remain steady.
To change the selected input
Press and hold the control button. The LED indicating the selected HDMI input will switch to the
other input. Release the button.
