miniDSP Ltd – Hong Kong / Email :
info@minidsp.com
/ Features and Specifications are subject to change without prior notice
P 14
Each filter has different phase and amplitude characteristics. We recommend you to look online for more information
about the specifics of each filter.
Bypass button allows you to Enable/Disable the filter. Make sure to bypass the filter if you do not need the filter enabled.
Linking feature allows you to link real time the settings of two crossover windows: a handy feature for stereo
environments requiring synchronized changes to both left and right channels.
Step 1: Select the channel you would like to link to from the drop down menu.
Step 2: Click on the “Link” tick box to enable the linking.
Note that the environment will warn you that all current crossover settings of the current channel will be copied over to the linked
channel.
At anytime during the operation, you can decide to “unlink” the channels by simply clicking on the “link” tick box.
4.1.7.5
Compressor / Limiter
4.2
Load/Save/Restore a configuration
4.2.1
Load configuration:
Use this feature to load a previously saved configuration into the slot of the currently selected “Configuration”. The file must be as
.xml format and previously saved from this plug-in. For complexity reasons, inter-plug-in compatibility is not supported.
4.2.2
Save configuration
Use this feature to save your audio settings configuration. The following dialog box allows you to save the file anywhere on your PC as
a .xml format. Only the currently selected memory will be saved in an XML.
When saving a configuration, note that the following settings will not be saved as part of the configuration:
o
Master volume control from Remote
o
Source selection (e.g. SPDIF/AES-EBU/Toslink)
o
Input mode (Stereo/Mono)
These settings being “general platform settings” rather than “Configuration specific settings” and therefore wouldn’t be saved as part
of a configuration.
4.2.3
Restore current configuration only
Use this action to restore the current/active configuration of your unit. The remaining 3 configuration will be un-touched.
4.2.4
Restore Factory default
Use this feature to restore the board back to factory default. Warning that all configurations will be restored back to default from this
action.
Comp/ Limiter metering
shows real time amount of
attenuation by comp/limiter
Bypass Comp/ Limiter
Comp/ Limiter chart
Typical Comp/Limiter settings
A compressor/Limiter allows dynamic range compression of the signal to prevent damage of your speakers. Extensive information is
on the use of compressor/limiter. Please take the time to familiarize yourself with such processing block before
using it.
