16
if for some reason, they are not, you can link them manually following the steps indicated below.
To pair the camera and the monitor follow the next steps:
1. Press the MENU/Back
key and the menu will pop up;
2. Press the UP
key or DOWN key until the camera icon is highlighted then press RIGHT
key to enter into the sub-menu;
3. Press UP
or DOWN key to select ADD camera icon
then press RIGHT key enter
into the sub-menuen;
4. Press RIGHT
/LEFT /UP
/DOWN key to select the desired camera to add;
5. Press
key to search for a camera unit. The LED indicator (2) will begin to flash in green.
6. While the LED indicator is flashing, press the link button on the camera (5).
7. Once paired, the LED indicator will stop flashing and the image of the camera will show
immediately on the monitor unit screen;
8. If unsuccessful, please repeat above steps;
For various reasons you may lose the connection between the monitor and a camera which is
already connected. Should this be the case, repeat the process explained above to connect the
camera with the monitor again.
Note:
Before starting the pairing process, make sure that the camera and the monitor are close
to each other.
Note 2
: Each camera can be linked just with one monitor at a time.
Nota 3
: If the monitor and the camera, for some reason, have left the factory without being
paired, you will have to do it manually adding the camera to channel 2, 3 or 4. You won’t be able
to pair the camera again with channel 1 until you have paired it in another channel and remove
the channel 1 camera.
5.2.7. DELETE CAMERA
To delete one of the cameras connected, follow the next steps:
1. Press the MENU/Back
key and the menu icon will pop up;
2. Press the UP
key or DOWN key until the camera icon is highlighted then press RIGHT
key enter into the sub-menu;
3. Press UP
key or DOWN key to select DELETE camera icon
then press RIGHT key
enter into the sub-menu;
4. Press RIGHT
/LEFT /UP
/DOWN key to select the desired camera to delete and
press the
key.
Note:
If you only have one camera paired to the monitor, you won’t be able to remove it.
Note 2:
A channel needs to be deleted before pairing to a new camera unit.
6. MAINTENANCE
• Clean the surfaces of the camera with a soft, lint-free cloth.
• If the unit becomes dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow
water into any openings.
• Never use cleaning agents or solvents.
ENGLISH
Summary of Contents for Digital Camera 2.4"
Page 2: ...MNLXX XXXXX ...
Page 71: ......
