5. USAGE INSTRUCTIONS
5.1. BEFORE USE
5.1.1. CAMERA POWER SUPPLY
The camera or baby unit of this baby monitor is designed for use with the battery or with
the AC/DC adapter supplied.
1. Place the connector socket (VI) at the rear of the baby unit.
2. Connect the adapter cable to the mini-USB socket of the camera. Only use the adapter
supplied.
3. Plug in the adapter to the mains.
Warning: Danger of Strangulation – Keep the cable out of reach of the baby. NEVER
place a camera with cables less than 1 metre away from the cot. Never use extension
cables with AC adapters. Only use the AC adapters supplied.
5.2. OPERATION
5.2.1. TURNING THE CAMERA ON/OFF
To turn the camera on or off, keep the on button (II) pressed in for two seconds. The power
LED (VII) will go on and off depending on whether you turn the unit on or off.
When you have installed the camera and turned it on, you can see the images and listen to
the sounds captured in your baby's room via the monitor.
Remember that to see the image of this camera on your monitor you must first pair the
units following the instructions shown in section 5.2.9.
5.2.2. INFRARED NIGHT VISION (AUTOMATIC)
The infrared night vision function enables the camera to capture images of your baby or of
the monitored area when it is dark or there is little light.
In this mode images will only be shown on the monitor in black and white and you will only
be able to see images situated less than 2 metres away.
The camera constantly monitors the light level and automatically switches to infrared mode
when there is not enough light for normal vision.
5.2.3. CHOOSING THE CAMERA AND SCAN MODE
This baby monitor allows up to 4 cameras to be linked to the same monitor. To choose the
camera from which you wish to view the image at this time, keep the zoom/menu button
pressed and use the buttons
▲
and
▼
to choose the camera selection icon and press
the remote/accept button to confirm. Using the buttons
▲
and
▼
again, choose from
between the four cameras the one you wish to view and press the remote/accept button
again to confirm the selection.
If you prefer the monitor to show the image of each camera for a few seconds in cyclical
fashion, choose the SCAN option and confirm by pressing the remote /accept button.
5.2.4. LULLABIES
You can calm the baby down so it can sleep more easily by means of a soothing lullaby
which will play on the baby's unit. To activate this function, keep the zoom/menu button
pressed and use the buttons
▲
and
▼
to choose the lullabies icon and press the
remote/accept button to confirm. Using the buttons
▲
and
▼
again, choose from between
the three lullabies the one you prefer or disable the lullabies by selecting OFF. Press the
remote/accept button again to confirm the selection.
en
