MOULDER FUNCTION
7.4
T1
BF-NGB7
SAFETY NOTES:
SAFETY NOTES:
SAFETY NOTES:
SAFETY NOTES:
SAFETY NOTES:
-
Each working shall be separately considered and you have to fit the proper guard.
-
The min. opening diameter on the table will be determined according to the tool and the height
at which the cutter is set.
To get the opening as small as possible use the supplied rings (T fig.7.2).
In this way you reduce the risk that the workpiece oscillates and fits into the cutters during its
passage on the hole.
-
Adjust the fence in order to reduce the opening between fence halves and tool to a minimum.
-
The tool adjustment shall be carried out with the machine off and with proper instruments
(gauge, comparator).
7-3
7-3
7-3
7-3
7-3 VER
VER
VER
VER
VERTICAL
TICAL
TICAL
TICAL
TICAL ADJUSTING OF THE SPINDLE
ADJUSTING OF THE SPINDLE
ADJUSTING OF THE SPINDLE
ADJUSTING OF THE SPINDLE
ADJUSTING OF THE SPINDLE
It serves for setting the tool to the worktable.
The vertical adjusting of the spindle occurs by turning handwheel (A fig.7.4).
To lock handwheel tighten knob (B).
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
To take up eventual slack, reach the position always with motion upwards.
Each turn of the handwheel corresponds to a 2 mm adjusting.
Summary of Contents for FORMULA T1
