MINIMOTO
™
GO KART
15
HOW TO RIDE YOUR MINIMO-
TO™ GO KART:
IMPORTANT:
TWO PEOPLE SHOULD BE
INVOLVED IN THE ENTRY OF THE DRIVER INTO
THE GO KART TO PREVENT ACCIDENTAL
MOVEMENT OF THE VEHICLE OR FALLING.
NOTE:
It will take a little practice to get
used to driving. Take it slowly and start in a
location that is very open and away from
obstacles or obstructions. Take steps to learn
the proper way to use your left foot for brak-
ing purposes.
1)
WARNING:
BEFORE DOING ANYTHING,
REMOVE THE POWER SHUT-OFF “T” HANDLE
BEFORE ATTEMPTING ENTRY INTO THE VEHI-
CLE. THIS WILL PREVENT ACCIDENTAL
ACCELERATION WHEN LOADING.
2) CHECK TO SEE THE “ON/OFF” SWITCH ON
THE STEERING WHEEL IS IN THE “ OFF ” AND
THE “FWD/REV” SWITCH IS IN THE “ FWD”
(forward) POSITION.
3) Loosen the
knob under the
steering col-
umn. (Fig. 15)
4) Slide the
Steering Wheel
up and rotate it
forward to allow
easier access
to entry. (Fig.
16)
5) Step in the vehicle and carefully slide
down into the seat.
6) Place the
Steering Wheel
back to the driv-
ing position.
Re-tighten the
knob under the
steering column
until it is tight.
(Fig. 17)
7) Put on the
seat belt and
adjust until
tight but com-
fortable low around the driver’s waist. (Fig.
18)
8) Place your feet on the pedals. (Fig. 19)
9) Have some-
one outside the
vehicle insert
the Power shut
off “T” handle
into the hole at
the rear of the
Go Kart near
the battery box.
IMPORTANT:
This should be
done ONLY after
the rider is in
position to pre-
vent accidental
movement of the Go Kart while the driver is
loading. (Fig. 20)
NOTE:
If the “T” handle is not in its proper
location, the vehicle will not move.
Fig 15
Fig 17
Fig 18
Fig 19
Fig 20
Fig 16
