MINIMOTO
™
GO KART
8) Carefully unplug the connector to the Training Mode/
Normal mode switch. (Fig. 36)
9) Using an Allen Key, remove the entire seat by unscrew-
ing the four bolts in the seat bottom. (Fig. 37) . Lift the
seat out of the vehicle.
10) Use the Allen key to remove the four bolts holding down
the rear cover. (Fig. 38)
11) Carefully flip up the rear cover [
NOTE:
The charging
port will still be connected. Be careful not to pull hard on
the cover]. The Motor and Chain will now be exposed under
the battery holder plate.
12) Using an Allen key, unscrew and loosen the two bolts
on each side of the Motor which hold it to the chassis
(Fig.
39) . Loosen the bolts until you can easily slide the motor
by hand. You do not need to remove the bolts entirely.
13) Loose two adjustment nut (Fig. 40) . Push the motor by
hand until you have increased the tension in the chain to
the maximum.
NOTE:
DO NOT FORCE THE MOTOR WITH A
LEVER OR THE CHAIN MAY BREAK.
14) Tighten the two bolts holding the motor to the frame
tightly so that the motor will not slip.
15) Replace the rear cover and secure it with the four
bolts.
16) Reconnect the connector to the Training Mode/Normal
Mode switch
17)
Replace the seat:
NOTE make sure that the SEAT
BELT is back to the correct position.
18) Replace the side pods, battery, and battery cover in
reverse order.
21
Fig 36
Fig 37
Fig 38
Fig 39
Fig 40
8) Carefully unplug the connector to the Training Mode/
Normal mode switch. (Fig. 36)
9) Using an Allen Key, remove the entire seat by unscrew-
ing the four bolts in the seat bottom. (Fig. 37) Lift the
seat out of the vehicle.
10) Use the Allen key to remove the four bolts holding down
the rear cover. (Fig. 38)
11) Carefully flip up the rear cover [NOTE: The charging
port will still be connected. Be careful not to pull hard on
the cover]. The Motor and Chain will now be exposed under
the battery holder plate.
12) Using an Allen key, unscrew and loosen the two bolts
on each side of the Motor which hold it to the chassis. (Fig. 39)
Loosen the bolts until you can easily slide the motor by hand.
You do not need to remove the bolts entirely.
13) Loose two adjustment nut (Fig. 40). Push the motor by
hand until you have increased the tension in the chain to
the maximum.
NOTE: DO NOT FORCE THE MOTOR WITH A
LEVER OR THE CHAIN MAY BREAK.
14)Tighten the two bolts holding the motor to the frame
tightly so that the motor will not slip.
15) Replace the rear cover and secure it with the four
bolts.
16) Reconnect the connector to the Training Mode/Normal
Mode switch
17)Replace the seat: NOTE make sure that the SEAT
BELT is back to the correct position.
18) Replace the side pods, battery, and battery cover in
reverse order.
