Connect the servos to a powered receiver. Bind the receiver with your transmitter to make the
servos return to their neutral point. Test whether the servos are normal, and install the servo arms
according to the position shown in the picture. (use screws to fix the servos on the servo base
from below.)
Note: Important step. Please make sure that the servos have been tested and installed in strict
accordance with the following picture. After assembling the model, it will be not able to adjust.
Combination of side plate and servo base.
Pay attention to keep both sides symmetrical without distortion. Please wait until the glue is
completely cured before the next installation step.
