Minipack-Torre Pratika 56 CS Series Installation, Operation And Maintenance Manual Download

Page: 24 / 116

Chapter 1. Description

1.1. Preface

This manual has been drawn up in compliance with the UNI10893 standard dated July 2000. It is meant for all users in
order to enable them to use the machine correctly. Keep it in a place which can be easily accessed in the proximity of the
machine and which is known to all users. This manual is an integral part of the machine for safety reasons. We wish to
specify the symbols in use here below in order to improve understanding of them.

ATTENTION:
Accident prevention rules for the operator. This warning indicates the presence of dangers which
can injure the person operating on the machine.

ATTENTION:
Hot parts. Shows the danger of burning, thus involving the risk of a serious accident for the
exposed person.

WARNING:
It indicates the possibility of damaging the machine and/or its components.

It is extremely important to read this entire chapter as it contains important information regarding risks that personnel are
subject to in the event of incorrect use of the machine. These basic standards must be observed as well as specific
standards applicable in the country of installation.



Never use the machine for purposes other than as specified in the sales contract.



Never allow unauthorised personnel to perform repairs or other operations on the machinery.



The operator must be familiar with all warnings related to the tasks in hand and always be informed by the head of
the site regarding risks.



Ensure that all clothing is tightfitting, with particular reference to cuffs or other loose clothing.



Always use suitable personal protective equipment such as gloves, safety footwear etc. as specified by accident
prevention standards.



Ensure that all operating areas and transit zones are kept clear, clean and adequately lit at all times.



Eliminate all safety hazard conditions before using the machine and always notify the head personnel of any
malfunction.



Never use the machine in the event of fault.



Never tamper with safety devices or circuits.



Never operate the machinery with safety devices disabled or fixed guards removed.



Never leave the machine unattended with guards disassembled or mounted incorrectly.



Never perform modifications on the machine without prior authorisation from the manufacturer.



The electrical enclosure must remain closed during operation.



The key to open the electrical enclosure must be kept by a specialised and authorised member of personnel.



The manufacturer declines all liability for damage or phisical injury caused by failure to observe safety standards.

1.2. Machine performance

The L-sealer “Pratika 56CS” has been designed to wrap loose, individual or groups of products (foodstuff, household
item, toys etc.) using single fold heat shrink film.
The machine can be fed manually or operate in series with other machinery. If it is fed by a qualified technician (machine
operator) he needs to be instructed accordingly, and he has to be able to advise it can maintenance technician in case of
malfunctions or machine anomalies.
Operate in “AUTOMATIC” mode.
The machine is managed by a control logic housed in the control board.
Thanks to the versatile design of the machine, a wide range of products can be processed with different shapes and
sizes.
Moreover it is possible to perform operations, using “MANUAL” mode controls. Packs are handled by conveyors housed
inside the framework.
The machine is also equipped with a device for the recovery of scrap film, to avoid the presence of waste film inside the
operator work zone and eliminate the risk of obstacles and consequent safety hazards.

CAUTION!

This machine is NOT designed for explosion-proof applications; it is a standard model and therefore must
never be installed or operated in zones subject to the risk of explosion.