NOTE:
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.
Step 1. Remove 1 of 3 screws from the mounting plate and loosen the other 2 screws. (Do not remove)
Step 2. While holding the light kit, firmly snap the wire molexes together. (Fig. 18)
Step 3. Place the key holes from the LED light kit over the 2 screws previously loosened from the mounting plate, turn LED light kit until it locks in
place at the narrow section of the key holes. Secure by tightening the 2 screws previously loosened and the one previously removed. (Fig. 18)
Step 4. Raise the glass shade cover up against the LED light kit and secure it to the fan by turning glass shade clockwise untilsnug. DO NOT
OVERTIGHTEN. (Fig. 19)
LIGHT KIT INSTALLATION
9
