SYMPTOM
Fan Sounds Noisy
SOLUTION
Allow a 24-hour "break in"
period. Most noises associated
with a new fan will go away
during this time.
Make sure outlet box is
secured to building structure,
if necessary use the wood
screws provided to further
secure outlet box to joist.
Make sure hanger bracket is
secure to the outlet box,
screws are tight.
SYMPTOM
Fan Wobble
SOLUTION
NOTE: All blade sets are grouped by
weight. Because wood and plastic
blades vary in density, the fan may
wobble even though blades are
matched.
Make sure outlet box is secured to
building structure, if necessary use the
wood screws provided to further secure
outlet box to joist.
Make sure hanger bracket is secure to
the outlet box, screws are tight.
Use the balancing kit provided if the
wobble is excessive (follow instructions
included with balancing kit)
SYMPTOM
Fans/Light Turn On
and Off Unexpectedly
SOLUTION
This is caused by
interference, change
the code frequency
from the transmitter
and receiver. Any
code combination
will operate the fan
or light (remote
controlled fans only).
(if applicable)
TROUBLESHOOTING
SYMPTOM
Fan will not start
SOLUTION
Check to make sure the wall switch is turned
on.
Check circuit fuses or breakers.
Caution! Make sure the power is turned off
before performing the following steps.
Remove canopy and check wire connections.
If using a remote controlled fan; check to see
that the dip switches from transmitter and
receiver are set to the same frequency code.
Check wall control transmitter connections (if
applicable).
Note: Fan must be installed from a maximum
distance of 40 feet from the transmitting unit
for proper signal transmission between the
transmitting unit and the fan's receiving unit.
12
