Minka Group Minka Aire GEANT, Instruction Manual Warranty Certificate

CAUTION! THE HANGER BRACKET PLATE MUST BE INSTALLED DIRECTLY 

TO THE BUILDING JOIST USING THE TWO WOOD SCREWS AND WASHERS 

PROVIDED.
Step1. Remove two knock-outs from the oulet box to expose the joist. (Fig. 5)
Step2. Use the two wood screws and washers provided to secure the hanger 

bracket plate to the building joist via the knockout holes from the outlet box. (Fig. 6)
Step3. Secure hanger bracket to hanger bracket plate using the two hex nuts and 

washers provided, make sure nuts are securely tighten. (Fig. 7)
Step4. Loosen the two set screws and remove the hitch pin and lock pin from the 

coupling located on the top of motor assembly. (Fig. 8)

Step5. Remove hanger ball from downrod assembly by loosening set screws, 

removing the cross pin, and sliding ball off rod. (Fif. 9)
Step6. Carefully feed fan wires up through the downrod. (Fig. 10) Thread the rod 

into the coupling until the holes line up holes and replace lock pin and hitch pin. 

Tighten set screws.
Step7. Slip coupling cover, and canopy cover, and canopy onto downrod. (Fig. 11) 

Carefully reinstall hanger ball onto rod being sure that cross pin is in the correct 

position, set screws are tighten and wires are not twisted.
Step8. Place downrod rudder cover onto the hanger ball. (Fig. 11)
Step9. Lift the motor assembly and place hanger ball into the hanger bracket. Rotate 

the motor assembly as needed until the check groove from the hanger ball rests  firmly 

over the registration tab from the hanger bracket. Motor assembly should not rotate if this 

is done correctly. (Fig.12)

Step10. Secure the safety cable to the building structure using a wood screw. 

If necessary, connect the extension safety cable to the safety cable (from fan), feed end of 

cable into clamp hole and firmly tighten screw, as noted in the circle insert of Fig.12