5
HANGING THE FAN
WARNING: All of the parts, hardware and components such as the
hanger bracket and hanger ball have been provided for your safety and
the proper installation of your new ceiling fan. The use of other parts,
hardware or components not supplied by Minka Aire
®
with the fan will
void the Minka Aire
®
Warranty.
REMEMBER to turn off the power. Follow the steps below to hang your
fan properly:
Step 1. Secure the Hanger Bracket & Seat to the ceiling outlet box using the
screws provided with your outlet box in conjunction with the lock-washers
provided with the fan. (Fig. 6)
Step 2. Loosen the two Set Screws and remove the Hitch Pin and Lock Pin
from the coupling located on the top of the Motor Assembly. (Fig. 7)
Step 3. Remove the Hanger Ball from the Downrod Assembly by loosening
the Set Screw and removing the Cross Pin. (Fig. 8)
Step 4. Carefully feed fan wires up through the downrod. (Fig. 9)
Thread Downrod into the Coupling until the holes are lined up and secure
with the Lock Pin and Hitch Pin previously removed, tighten Set Screws.
(Fig. 9)
NOTE:
NOTE: This fan comes with a 12” downrod. In addition you have been
provided with a wire harness which you can attached to the fans wiring
should you need to use a longer down rod. Please refer the owner's
manual included with the extension cord packge.
Step 5. Slip coupling cover, decorative canopy and canopy onto downrod.
(Fig. 10) Carefully reinstall hanger ball onto rod being sure that cross pin is
in correct position, set screws are tighten and wires are not twisted.
Step 6. Lift the Motor Assembly and place the Hanger Ball into the Hanger
Bracket. Rotate the Motor Assembly as needed until the check groove
from the Hanger Ball rests firmly over the registration tab from the
Hanger Bracket. Motor Assembly should not rotate if this is done
correctly. (Fig. 11)
