22 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
ADjUSTING THE LATCH COLLAR
a. With the motor in the deployed position, locate
the Depth Collar on the Shaft above the Steering
Housing.
b. While holding the Shaft, loosen the Depth Collar
Knob until the Shaft can slide up and down freely.
1
2
c. Raise or lower the motor to the desired depth.
d. Turn the motor control head to the desired
position.
e. Slide the Depth Collar against the Steering
Housing and tighten the Depth Collar Knob to
secure the motor in place.
NOTE:
Be sure the top of the motor is submerged
at least 12” below the surface of the water to avoid
churning or agitation of surface water.
a. With the motor in the stowed position, locate the
Latch Collar.
b. Using a #2 Phillips Screwdriver, loosen the screw
securing the Latch Collar in place.
1
Once the motor has been used, it may be necessary to adjust the Latch Collar up or down. The ideal adjustment is a slightly loose
fit that completely captures the Latch Collar in the Deploy Assist Lever when stowed.
Adjusting the Latch Collar
Propeller
Motor
Depth Collar Knob
12" Minimum Depth
Latch Collar
Depth Collar
Shaft
Screw
WARNING
The Control Head will create a pinch point if the Depth Collar
Knob is loosened and the Control Head slides to the top of the
Depth Collar. Grasp the Shaft and prevent it from sliding all the
way down to prevent the pinch point.
Summary of Contents for RIPTIDE POWERDRIVE
Page 1: ...RIPTIDE POWERDRIVE BOW MOUNT TROLLING MOTOR OWNER S MANUAL...
Page 43: ...minnkotamotors com 43 2018 Johnson Outdoors Marine Electronics Inc NOTES...
Page 45: ...RIPTIDE POWERDRIVE PROPULSEUR LECTRIQUE MONT SUR L TRAVE MANUEL DU PROPRI TAIRE...
Page 87: ...minnkotamotors com 87 2018 Johnson Outdoors Marine Electronics Inc REMARQUES...
