26 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
AUDIO MODES
• As soon as any remote button is pressed, the initial speed setting will be set to approximately the same value as the Speed
Control value on the Foot Pedal. The prop will not automatically turn on until the Prop ON/OFF button on the remote is
pressed.
• Pressing the Momentary Button on the Foot Pedal or adjusting the Speed Control dial will override the remote and receiver
function. Control of the motor will automatically go to the Foot Pedal. The prop speed will also revert to the current value of
the Speed Control dial on the Foot Pedal.
Operating without the Foot Pedal
(Foot Pedal only available on select models.)
• If the foot pedal is not being used, the CoPilot receiver will always react to any commands from the CoPilot remote.
AUDIO MODES
There are three receiver Audio Modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to
another, simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
Audio Pattern
What Condition Causes Audio Pattern
Audio Mode
1 Beep
Pressing the Increase Speed or Decrease Speed button
Modes 2 and 3
1 Beep
Pressing the Prop ON/OFF button to turn the Prop on
Modes 2 and 3
2 Beeps
Pressing the Prop ON/OFF button to turn the Prop off
Modes 2 and 3
Single tick every 1.5 seconds
When the Prop is active including when Speed Control dial is set to 0
Mode 3
1 Beep
Switching to audio Mode 1
All
2 Beeps
Switching to audio Mode 2
All
3 Beeps
Switching to audio Mode 3
All
1 Chirp
Every time the receiver is powered up and there is at least one remote learned
All
2 second long Beep
Every time the receiver is powered up and there are no remotes learned
All
5 Beeps
Speed Control dial on Foot Pedal (if applicable) is moved after speed has been adjusted
with remote
All
Steady Tone
Heard while holding down the Learn button on the receiver
All
4 Beeps
Heard after a remote button is pressed while the receiver learns it.
All
Ten second warbling sound that
transitions into a steady tone
Heard during the process used to clear all stored remote. after the learn switch is released,
a 2 second long beep will be heard
All
1 long Beep, 2 short Beeps, pause
(repeat)
Powered up with Momentary/Constant Switch in the CON position (or the Momentary
Button held) when the Foot Pedal (if applicable) is moved to momentary, the power up
audio will be heard
All
NOTE:
When the Foot Pedal (if applicable) is operating the motor and the propeller is on, the prop on indicator tick will
be heard if the receiver is set to Audio Mode 3.
Audio Mode
Function
Mode 1
All of the normal audible sounds mentioned in this owners manual, but no audible beeps for speed increase/
decrease or prop on/off.
Mode 2
Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off.
Mode 3
Same as audio mode 2 plus the prop on audible tick every 1.5 seconds.
Summary of Contents for RIPTIDE POWERDRIVE
Page 1: ...RIPTIDE POWERDRIVE BOW MOUNT TROLLING MOTOR OWNER S MANUAL...
Page 43: ...minnkotamotors com 43 2018 Johnson Outdoors Marine Electronics Inc NOTES...
Page 45: ...RIPTIDE POWERDRIVE PROPULSEUR LECTRIQUE MONT SUR L TRAVE MANUEL DU PROPRI TAIRE...
Page 87: ...minnkotamotors com 87 2018 Johnson Outdoors Marine Electronics Inc REMARQUES...
