36 |
©2016 Johnson Outdoors Marine Electronics, Inc.
SERVICE & MAINTAINANCE
TROUBLESHOOTING THE COPILOT
Cause
Effect
Solution
Remote is not transmitting.
The battery is discharged.
Replace battery.
Receiver may not have "learned" the remote.
Remote needs to be learned. See the Adding/
Removing Remotes section of this manual to learn
the remote.
With the foot pedal connected, the MOM-CON
switch is in the CON position. An audio response will
be heard if a button is pressed with the foot pedal in
the CON position.
The foot pedal switch must be placed in Momentary
Mode (MOM). The receiver will not accept any
commands from the remote with the switch in the
Constant Mode (CON) position.
If remote has been taken apart, the keypad and top
case may have been installed backwards.
Take remote apart. See the Replacing the Battery
section of this manual and reinstall case halves with
the proper orientation.
When receiver is powered up, it
sounds a beep pattern (1 long
beep, 2 short beeps, pause,
repeat).
The foot pedal Momentary/Constant Switch is in the
CON position.
The foot pedal switch must be placed in the MOM
position. The beeping sound will continue until the
switch is placed in the MOM position.
The prop is not turning but the
Prop ON audio pattern is still
going.
Prop Speed is set at "0".
Increase the Prop Speed above "0"
The Prop ON audio pattern occurs only in Audio
Mode 3
Switch Audio Mode to either Audio 1 or 2. See the
Audio Modes section of this manual.
