Installing Accessories
10
Installing Accessories
Attention
Installing accessories always requires that the printer be turned off
and unplugged.
If you purchased any additional printer accessories (such as a duplex option
or additional memory), then install them now. If installation instructions are
included with the accessory, follow them. If not, instructions are included in
the User’s Guide (in PDF on the Utilities and Documentation CD-ROM).
Plugging in/Turning on the Printer
1
Make sure the printer is turned off.
2
Plug the printer power cord into the printer
and into a dedicated, grounded,
surge-protected electrical outlet.
In compliance with UL guidelines,
“The appliance inlet is considered to
be the main disconnect device.”
3
Turn on the printer.
After approximately 180 seconds, the printer
displays “
IDLE/MAGICOLOR 2300DL
” in
the message window. If “
IDLE/MAGICOLOR
2300DL
” does not display in the message
window, recheck the setup.
The printer automatically switches to power-saving (Energy Saver) mode
after 30 minutes of inactivity. You can change the number of minutes in the
Engine/Energy Saver
menu.
Attention
Never turn off or unplug the printer while it is receiving data or printing.