79
78
CUSTOM FUNCTIONS
1 –
DX Memory Off
Film speed is always set to the DX-coded ISO. Non-DX-coded film is
set to the ISO of the previous roll.
Cust 4 – DX Memory
2 –
DX Memory On
Changes to the film speed for a DX coded roll are saved and applied
to future rolls with the same DX coded ISO. Use to consistently
over/under-expose a specific film type.
• Film must be loaded before the ISO can be changed.
1 –
Autoswitchover
Built-in flash pops-up when shutter-release button is pressed partway
down. Flash will fire when necessary.
Cust 5 – Flash Control in P Mode
2 –
Fill Flash (Manual Switchover)
Flash-mode button must be pressed to
raise the built-in flash (p27). Flash will fire
every time the shutter is released.
• The TTL exposure system will ensure
correct exposure.
• Push the built-in flash down to select
flash cancel (
).
CUSTOM FUNCTIONS
1 –
AF priority
Shutter will not release until
or
appears in the viewfinder.
Cust 1 – AF Release Priority
Cust 2 – Film Rewind Start
2 –
Release Priority
Shutter releases even if the focus cannot be confirmed. Use Release
priority when photographing moving subjects.
• When continuous-advance mode is selected, the camera will not update the
focus while the shutter-release button is pressed.
1 –
Automatic
Film is automatically rewound at the end of the roll.
2 –
Manual
Press the manual-rewind button to initiate
rewind. (p29).
Cust 3 – Film Tip
1 –
Film is completely rewound into the cartridge.
2 –
Leader is left out of the
cartridge after rewind.
• Sliding the main switch to LOCK
during rewind causes the film to be
rewound into the cartridge when the
power is switched back on.
