Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
10-44
3.
Touch
OK
on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic
Screen.
• APS and AMS are automatically released, and 1.000 (100%) is selected as
a magnification ratio.
• Copy mode is automatically set to 1
a
1. If 1
a
2 is selected, Platen store
mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
For details on positioning originals, see p. 3-4 to p. 3-9.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [
START
].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
Having Any Problem?
The AUTO layout function may not operate properly if the lighting in the work
place is directly over the platen glass. In this case, consult your service
representative about an appropriate place for installation.
Summary of Contents for CF5001
