63
If the memory card is filled or the shutter button is released before the series has completed, the
camera will reset and the entire bracket must be made again.
To make a flash bracket, set the digital-effects switch to the exposure position and raise the camera
flash. When using flash, the bracket will not advance automatically; the shutter-release button must
be pressed for each frame of the series. Once the serie begins, the focus and exposure are fixed.
The remaining number of frames in the bracket series is displayed on the monitors next to the brack-
eting icon.
When exposure brackets are made in S exposure mode, the aperture controls the bracket. In A and
M modes, the shutter speed controls the bracket. The aperure can be used to control the bracket in
M mode by setting the digital-effects switch to the exposure position and holding the digital-effects
button during the exposures. Both the aperture and shutter speed can control the bracket in P mode.
NOTES ON BRACKETING
Normal
Under
Exposure bracket
Compose the picture as described in the basic recording section (p. 27). Press the
shutter-release button partway down (1) to lock the exposure and focus for the series;
the camera will continue to focus during the series if set to continuous AF (p. 83).
Press and hold the shutter-release button all the way down (2) to make the bracket
series; three consecutive images will be captured.
1
2
Number of frames in brack-
eting series
Frame counter
Over
Summary of Contents for DIMAGE 7HI - SOFTWARE
Page 1: ...INSTRUCTION MANUAL E 9222 2778 11 MM A208 ...
Page 2: ...2 ...
