66
A
DVANCED RECORDING
Used for self-portraits, the self-timer will delay the release of the shutter for approximately ten sec-
onds after the shutter is released. The self-timer is set with the function dial (p. 48).
With the camera on a tripod, compose the picture as described in the basic record-
ing section (p. 27). Focus lock (p. 28) or the Flex Focus Point (p. 45) can be used
with off-center subjects. Press the shutter-release button partway down (1) to lock
the exposure and focus. Press the shutter-release button all the way down (2) to
begin the countdown. Because focus and exposure are determined when the shutter-
release button is pressed, do not stand in front of the camera when taking a self-
timer image. Always confirm the focus with the focus signals
before beginning the countdown (p. 29).
During the countdown, the self-timer lamp on the front of the
camera will start to blink and is accompanied by an audio signal.
A few seconds before the exposure, the self-timer lamp will blink
rapidly. The lamp will glow steadily just before the shutter fires. To
stop the countdown, press the pro-auto button or change the
position of the flash (lift it or push it down). The audio signal can
be turned off in the basic section of the setup menu (p. 118).
SELF-TIMER
The self-timer can be used to minimize camera shake with long exposures. When using the
camera on a tripod, photographs of static subjects (landscapes, still-lifes, or close-up pho-
tographs) can be made with the self-timer. Because no contact is made with the camera during
exposure, there is no risk of camera shake caused by the operator.
Shooting tips
1
2
Summary of Contents for DIMAGE 7HI - SOFTWARE
Page 1: ...INSTRUCTION MANUAL E 9222 2778 11 MM A208 ...
Page 2: ...2 ...
