DiMAGE Scan Multi PRO
37
LOADING THE FILM HOLDER
Removing a Film
While sliding the button on the cover of the
attachment, lift the film cover.
Removing an Attachment
1. While sliding the button on the cover of the
attachment, open the cover, and while sliding
the lever on the upper part of the holder to the
right, lift the cover and remove the pins.
2. While sliding the lever on the middle part of
the holder to the right, lift the attachment.
5.
Place a film on the mask with the
emulsion side down while
aligning the lower side of the film
with the film guide (at the upper
or lower side).
6.
Close the film cover of the holder
until it clicks.
• Be sure to place the
appropriate mask and
then place a film when
scanning. Otherwise, the
interference fringes with
the concentric circles-
pattern may appear on the
image after the scanning
is performed.
Summary of Contents for DiMAGE Scan Multi PRO AF-5000
Page 1: ...E INSTRUCTION MANUAL 9224 2887 11 H A107 ...
Page 130: ...130 NOTES ...