Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
D-7
No.
Part Name
Removal Procedure
1
Front Door
Swing down No. 1.
!
Remove two Front Door hinge shafts.
Remove one belt mounting screw inside the Front Door.
2
Control Panel
Raise No. 12.
!
Swing down No. 1.
!
Open No. 8.
!
Re-
move No. 7.
!
Swing down No. 14.
!
Remove No. 13.
!
Remove two control panel mounting screws.
!
Remove two
magnet attraction plate screws.
!
Unplug one connector
from MSC Board.
!
Remove one connector.
3
Original Width Scale
Raise No. 12.
!
Remove two scale mounting screws.
4
Original Glass
Note:When the Original Width Scale has been removed, use
care not to lose two springs.
5
Rear Upper Cover (Small)
Raise No. 12.
!
Open No. 14.
!
Remove No. 13.
!
Re-
move the screw cover.
!
Remove one Rear Upper Cover
(Small) mounting screw.
6
Rear Upper Cover
Raise No. 12.
!
Open No. 14.
!
Remove No. 13.
!
Re-
move No. 5.
!
Open No. 8
!
Remove No. 7.
!
Remove
one Rear Upper Cover mounting screw.
7
Right Cover
Open No. 8.
!
Open the Multi Bypass Table.
!
Remove
four Right Cover mounting screws.
8
Right Door
(Manual Bypass Unit)
Open No. 8.
!
Remove two cover mounting screws.
!
Remove the harness from one wiring saddle.
!
Unplug
three connectors.
!
Remove two Right Door mounting
screws.
9
Counter Cover
Snap off the Counter Cover. (It is secured by catches at two
places.)
10
2nd Drawer
<Except 120V Areas>
See p. D-17
11
1st Drawer
<120V Areas>
See p. D-18
12
Original Cover
Remove No. 12 by pulling up.
13
Upper Left Cover
Swing down No. 14.
!
Remove six Upper Left Cover
mounting screws.
14
Left Door (Exit/Duplex
Switching Unit)
See p. D-61
15
Middle Left Cover
Remove No. 13.
!
Remove two Middle Left Cover mounting
screws.
16
Rear Cover
Remove six Rear Cover mounting screws.