Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
D-91
(13) Adjustment of the Image Trailing Edge Erase Width
z
Requirement
1134D134AA
Dimension A
z
Important
D
This adjustment should be made after the “adjustment of the image leading edge erase width”.
D
Before this adjustment can be made, “Trailing Edge Erase” on the “Tech. Rep. Choice 2” screen
must be set to “Yes”.
1136D042AA
3.
With the “Adjust 1/2” menu on the screen, touch Next
to show the “Adjust 2/2” menu.
4.
Touch the select key
t
or
s
to highlight “A13 Trailing Edge Erase Adjust”.
1156D166CA
1156D164CA
D
The erase width, dimension A, on the copy of the GTC-test
chart should measure 0.5 to 5.5 mm.
D
Setting range: 42 to 58.
1.
Place the GTC-test chart face down on the Original Glass
and align its rear left corner with the reference marker on
the Original Width Scale. Then, lower the Original Cover.
2.
Make three single copies on A3 or 11”
17” paper in full
size mode and check the third copy for trailing edge erase
width.
(If the erase width deviates from the specifications, per-
form the following steps to make the adjustment of image
trailing edge erase width.)