Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
D-97
(3) Adjustment of the PC Drum Paper Separator Finger Position
z
Requirement
D
The gap between the PC Drum and Paper Separator Fingers should be 1.0
"
0.5 mm when Separator
Solenoid SL1 is in the deenergized position.
z
Important
D
Use care not to deform the Separator Fingers during the adjustment procedure.
1136D053AA
1136D054AA
1136D055AA
1136D056AA
1.
Attach the PC Drum Paper Separator Finger Positioning
Jig to the IU.
2.
Using an Allen wrench, adjust the position of one of the two
Paper Separator Fingers. (Either one will do.)
D
With the solenoid in the deenergized position, the tip
of the finger should be at a point between A and B,
preferably more on the B end.
D
With the solenoid energized, the tip of the finger
should touch C.
A
41.5 mm
. . . . . . .
B
40.5 mm
. . . . . . .
C
40.0 mm
. . . . . . .
Adjusting Instructions
3.
After this adjustment, check that the other finger also
meets the above requirement.
NOTE
If the fingers cannot be positioned correctly through
steps 2 and 3, loosen the two solenoid mounting
screws and adjust the position of the solenoid. Then,
repeat steps 2 and 3.
