Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
S-35
1149SBS050408A
8. RD Mode
Tech. Rep. Mode
"
RD Mode
Touch Panel
Display
Setting (The default is
.)
Highlighted
RD Mode
Make the initial settings of the copier for the Data Terminal.
ID Code
Entering a 7-digit ID code from the 10-Key Pad enables making the
following settings. When the ID code is entered and transmitted after
the initial settings have been made, it executes the transmission of
MAINT. START to the Center.
Maintenance
Used to make the initial settings and various transmissions.
DT Setting
Enter the following data.
CT-ID
Enter the 4-digit ID number of the Center which has been programmed
in the Center personal computer.
DT-ID
Enter the 6-digit ID number of the Data Terminal.
TEL No.
Enter the 19-or-less-digit phone number of the modem connected to
the Center personal computer.
Note 1: When the office extension and outside line use different sys-
tems, enter “P” for a “pulse” telephone line or “T” for a “tone”
telephone line before the outside line number.
Note 2: The time it takes the private branch exchange (PBX) system to
switch from the extension line to the outside line varies de-
pending on the type of PBX system used. Set this time as
follows.
Fixed switching time: Enter the pause code “–” (a single “–”
lasts 2 sec.).
Varying switching time: Enter the wait code “W.”
Common DT
Settings of the following functions.
Dial Mode
Select the type of telephone line of the user.
Tone line
Pulse line
Tone
Pulse
Auto Receive
Choose “Yes” or “No” for the auto reception function.
YES
NO
Note: Select “Yes” if the line is dedicated to the Data Terminal.
Result Code
Set the value according to the type of modem on the copier.
Note: Don’t use this function as long as “5” has been set for it.
Report Format
Japan only
10 BIT
RAM Clear
Reinitializes the Data Terminal.
Maintenance
NO
