Interleaf EP5000/EP4000 GENERAL, MECHANICAL/ELECTRICAL
97.04.01
M-60
1156SBM1802A
18-2. Drawer Paper Lifting/Lowering Mechanism/Control
(1) Metric Areas
D
The paper lifting mechanism raises the paper in the drawer so that the top of the
paper stack is pressed against the Paper Take-Up Roll at a constant pressure.
D
When slid into the copier, the drawer presses the Drawer Set Lever which engages
Lift-Up Motor Gear 1 with Paper Lifting Arm Gear 2.
D
At the same time, the Drawer Set Sensor (PC61 /PC62) is blocked (goes LOW) and
after 1 msec., the Lift-Up Motor (M13/M14) starts turning, causing the Paper Lifting
Arm to raise the Paper Lifting Plate.
D
When the drawer is slid out, Lift-Up Motor Gear 1 is disengaged from Paper Lifting
Arm Gear 2, lowering the Paper Lifting Plate.
1st/2nd Drawer
Lift-Up Motor
M13/14
Paper Lifting Arm
Gear 2
Gear 1
4425M004AA
Rear
Front
When Drawer is Slid in
1st/2nd Drawer Lift -Up
Sensor (PC65/66)
4425M005AA
D
The Paper Lifting Arm further raises the paper
after the top sheet of paper is pressed against
the Paper Take-Up Roll. As the light blocking
plate blocks the Lift-Up Sensor (goes LOW), the
Lift-Up Motor (M13/M14) stops.