- 8 -
(Fig. W)
Tighten the Lock Nut until
it touches the housing
(Fig. U)
(Fig. V)
Why My Remote Shifter Doesn't Work Properly?
If you have a shifting issue where you can't set the remote at L or H, your cable may be stretched.
To fix this problem, follow the adjust the cable tension.
1.
Set your remote shifter at "H" position and remove the shifter from your handlebar, then straighten the cable as
much as possible.
2.
Pull out the plastic cover cap on foot of the remote cable. (see Fig. U)
3.
Hold the inside Adjusting Screw and push it toward the shifter, then adjust the Lock Nut to set the cable
tension properly. (see Fig. V)
4.
Install the cover cap again.
Adjusting Screw
Cap
Lock Nut
If you wish to use a tire size 24x1.75" or smaller,
you need to install the Z-shaped "Small Wheel
Adapter" between the Base Plate and the Mag
unit to raise up the roller height. (see Fig. W)
The direction of Z-adapter is fixed so follow
the arrow printed on the top and make sure it's
pointing toward the front (toward your bike).
If the drive roller cannot reach the tire even if
you install the adapter, make sure you have been
installed in correct direction.
The mounting bolt configuration is a showin in
the Fig. W.
How To Use Small Wheel Adapter
Required Tools:
1 x 10mm Spanner, 1 x M4 Hex Wrench
Hex Head Bolt
Round Head Bolt
Z-Adapter
Rubber Shim
