- 7 -
1.
2.
!
!
!
Preparing R720 For Use
Adjust the quick
release properly
as the 1st step
At first, adjust the quick release properly so that
you can tightely fix the Front Frame by just
bending the lever.
This step shoud be done while the frame is
retracted.
Adjust the backside nut precisely so that you will
feel resistance on your palm when the lever comes
in horizontal.
Do it on both sides.
Do not use the lever to tighten.
Use the nut ONLY.
Extend
Tighten
firmly
Tighten
firmly
Make sure the belt is not on the frame (resting
on rollers) so it does not get caught when you are
extending the frame.
Pull out the Front Frame until it reaches the stopper,
and tighten the quick release lever firmly.
The lever should be directed to the floor.
Hook the roller belt to the groove on rollers.
Rotating the roller will help seat the belt properly.
Be careful not to pinch your finger.
Confirm the roller belt is hooked properly between
the center and front rollers.
It's not recommended to hook
the roller belt to the rollers
BEFORE extending the front
frame.
To do so, you need to hold
R720 by pressing the rear roller
with your foot. Keep a steady
pressure with your toe so the
R720 doesn't snap back from
belt tension and cause possible
injury.
Tighten the quick levers firmly.
If you ride on the R720 roughly,
the quick release may come
loose and the front frame will
be retracted, then you may fall
forward.
