!
If the rear tire has touched any other parts than the Drive Roller, the part may be
damaged and your tire will wear out quickly.
!
It is impossible to adjust the rear wheel position by adjusting the left side coupling
position. It just works to adjust the coupling distance.
5.
To remove the bike from M70-R/M80-R, loosen the knob then lift up om the clamp.
If you remove the bike without changing the roller position, the next installation may become difficult
because the rear wheel has been pushed forward by the roller.
- Page 7 -
How To Adjust Resistance Level
1.
Wind the band around the handlebar and hook the metal ring to the gutter on the remote shifter base.
(see Fig. O-1)
3.
The soft fabric band is pre-adjusted to fit normal 22mm diameter handlebar.
If you need to mount onto an oversized or specially shaped handlebar or stem, adjust the band (see Fig. P).
At this moment, we suggest you to slide the guide pin downward (see the column) to loosen the band for
easier work.
1
2
1
2
3
V100/V130 features a convenient remote shifter lever. You can install it on the handlebar or stem, then you can
control the resistance level without getting off the bike.
Decrease
Increase
(Fig. O)
(Fig. P)
(Fig. Q)
2.
F
lip up the lever to lock (see Fig. O-2). If it is loosened, adjust the band tighter as per instructed in the
following section.
4.
To increase the resistance, twist the lever toward "H". To decrease the resistance, twost the lever towawrd
"L". (see Fig. Q)
You can choose from 7 different levels to suit your desired workout level.
