- 9 -
How To Install Foot Step
110mm
Required Tool:
Phillips Screwdriver, 13mm Open Spanner
(not the closed type)
Please note you will be up higher than floor once on the rollers. This makes it difficult to touch the ground so you need to install
the Foot Step to eliminate this problem.
The Foot Step is packed in disassembled condition. Please follow the steps below for setting-up.
1
Loosen the screws to remove the bracket.
2
Fully screw the M8x15 Bolt to the Bracket from
backside, and screw the Long Nut firmly with spanner.
Foot Step Body
Bracket
Screw
Long Nut
M8x15
Cap Bolt
3
Tighten the Bracket to the Step Body again.
Put the Lock Nut through the Adjuster, and
screw into the Long Nut.
4
Set the Adjuster length to 110mm (from the groove
bottom to the adjuster top).
Tighten the Lock Nut toward the Long Nut with
spanner to fix the position.
Adjuster
Lock Nut
Put the Foot Step over the Center Frame.
If the Adjuster is too short and doesn't reach the floor, extend it.
5
Warranty Service
(Fig. N)
(Fig. O)
(Fig. P)
(Fig. Q)
Minoura offers 1-year limited warranty to this product from the date of your purchase.
Any natural wear and the problems caused by misuse or unapproved modification will not be covered by this program.
This warranty covers the original user only and is void if terms are not met.
For more information, refer the attached "Minoura Limited Warranty Policy" card, and visit Minoura's web site for the latest
information.
