- 4 -
How To Install Step-Bar
Required Tool :
Nothing
Install the Step-Bar to the Body. (Fig. A)
Put the Knob Bolt (Large) with the Round Collar into the plain hole on the Step-Bar, and screw it into the
thread hole on the Body.
Put the Knob Bolt (Small) with the Round Collar into the thread hole on the Step-Bar through the small hole
on the Body.
1
2
Step-Bar
(direction is specified)
Knob Bolt (Large)
+
M8 Flat Washer
Round Collar
Round Collar
Knob Bolt (Small)
+
M6 Flat Washer
(Fig. A)
The direction of the Step-Bar is specified. You cannot install it in the wrong direction.
!
!
You may find that the knob bolt spins freely and cannot be tightened further. This is by
design. You can retighten by pushing knob bolt towards the thread hole.
The Round Collar works to spread the pressure from the bolt in order to avoid
deforming the tube even if the bolt has been overtightened.
!
To retract the Step-Bar for storing compactly, remove the smaller Knob Bolt (Fig. B), loosen the larger Knob
Bolt until it spins freely, and pull the Step-Bar (Fig. C).
3
(Fig. B)
(Fig. C)
