- 6 -
2
3
1
How To Replace To 12mm Thru Axle
The original hub on your Kagura-DD is preset for the standard 9mm Q/R.
If your bike is equipped with 12mm thru axle system, you must replace the right side hub end with the supplied
special plug. (Fig. H)
Hub end for standard 9mm Q/R system
Hub end for 12mm Thru Axle
Apply the wrench to the original right side end plug, and
turn it counter-clockwise to remove while holding the
flywheel with your other hand. (Fig. I)
(Fig. H)
(Fig. I)
(Fig. J)
(Fig. K)
Install the supplied Rightside End Plug for
12mm Thru Axle to the hub.
Turn it by your hand first, then use the
wrench to tighten firmly. (Fig. J)
Installation is done.
