12mm Thru Axle System
Put the axle shaft into the hole on the left side of the bike frame end, slowly get the frame down to align to
the hub hole, and put the axle into the hub hole. Now the bike position has been fixed.
About The Direction of The Leftside End Plug
Compatible with the rear end width
in 142mm and 148mm only.
Change the direction of the Leftside
End Plug to the hub as shown in
Fig. Q.
142mm : Face the wider sleeve side inward.
148mm : Face the narrower sleeve side inward.
142mm
148mm
(Fig. Q)
How To Install 12mm Thru Axle and How To Mount Your Bike
1
2
3
4
Insert the supplied Leftside End Plug for 12mm Thru Axle into the left side of the hub. (Fig. Q)
Make sure the other side end plug has been replaced with the supplied Rightside End Plug for 12mm Thru
Axle. (Fig. H)
Hold the bike frame just above Kagura-DD and keep this position.
Screw the axle to the right side thread hole.
If your bike is equipped with a quick release type axle, adjust tightening and close the lever to hold securely.
- 9 -
Setting Foot Adjusters
(Fig. R)
Adjust all three foot adjusters under the body and step-
bar to insure that the Kagura DD is stable and that your
bike is vertical. (Fig. R)
The foot adjusters can be used to help level the bike,
especially with larger 29" MTB wheels, by fully extending
all three adjusters.
Turn the foot to adjust the length, and tighten the lock
nut toward the body or the step-bar to ifx.
Use the lock nut correctly to keep your
Kagura-DD stable.
!
