If you wish to use the tire sized 26 x 1.75" or smaller,
you need to install the supplied Z-shaped "Small
Wheel Adapter" between Base Plate and Mag unit to
raise up the roller height.
The direction of Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward your bike).
If the drive roller cannot reach the tire even if you
install the adaptor, make sure you have been installed
in correct direction.
Use the original cap head bolts for Base Plate, and
use the supplied hex head bolts for the Mag unit.
How To Use Small Wheel Adaptor
Hex Head Bolt
Cap Head Bolt
Z-Adaptor
Required Tools:
1 x 10mm Spanner
1 x M5 Hex Wrench
- Page 8 -
Why My Remote Shifter Doesn't Work Properly?
You may have a shifting problem that you cannot set at L or H position
properly due to the lengthened inner cable.
To fix this problem, follow the steps to adjust the initial cable tension;
1.
Set your remote shifter at "H" position and remove the shifter from
your handlebar, then straighten the cable as much as possible.
2.
Pull out the plastic Cap on foot of the remote cable. (see Fig. O)
3.
Hold the inside Adjusting Screw and push it toward the shifter, then
adjust the Lock Nut toward the VFS resistance unit until the nut
touches the housing to set the cable tension properly.
4.
Install the Cap again.
Adjusting Screw
Lock Nut
Cap
(Fig. O)
