Using The Small Wheel Adapter
<Required Tools> • M5 hex wrench
• 10mm open spanner)
If you wish to use any smaller wheel sized between 24 x 1.0" and 26 x 1.75" on the trainer, install the supplied Z-shaped
Adapter under the VFS unit. (Fig. S)
Remove two bolts which hold the VFS unit on the base plate by an M5 hex wrench. Then the VFS unit will be
removed.
Base Plate
Adapter
Install the supplied adapter on the base plate with the removed bolts. Make sure the direction of the adapter is
exactly same as shown in Fig. S. (Also printed on the top of the adaptor)
Wrong direction will set the VFS unit too close to the wheel and you cannot set the bike correctly.
Install the VFS unit onto the adapter with the supplied hex head bolts.
Be sure you should use a 10mm open spanner to tighten these bolts, not by a hex wrench.
10mm Open Spanner
(Fig. S)
1
2
3
Page : 9
