5
Description
Battery Installation / Removal
Suggest using two hand to push the battery cover and open it then install the battery. The metal contact end of the
battery should face left, slide the battery into the bay with 45 degree slant angle, then push the entire battery into
the bay. When the battery is in the proper position, replace the cover.
Recharge the Battery
Be sure to turn off the power when charging the battery.
Plug the USB end of the connection cable into the socket of the PC/MAC and plug the mini USB end of the
cable into the USB port of the unit. The red backlight will turn on when the battery is being charged.
Charging the Battery
The property of each lithium ion battery varies slightly. To optimize battery power, this product uses
state-of-the-art intelligent battery management technology to achieve maximum power supply time.
Notice:
When using a new battery for the first time, make sure to fully deplete (the product will shut down
automatically if there is no power) it before recharging. This product will automatically memorize the
properties of this battery and save its relevant battery power information. By following these instructions, you
will obtain optimum battery usage conditions.
For the first time, suggestion that you charge the battery for more than 4 hours.
Installing/Removing the Memory Card
The memory card slot is located on the side of this product. Push the memory card into the slot according to the
marking on the unit.
To remove the memory card, just press the memory card to eject it automatically.
Summary of Contents for DMP-3
Page 1: ...DMP3 Instruction manual ...
