One to One Code Matching:
Press the "set" and "*" keys combined for 3 seconds, LED indicator starts flashing.
Camera receive the signal and power on, LED indicator will go off if code matching
successfully. The camera can be controlled by this wireless remote control only after one
to one code pairing. Otherwise please clear the code matching of this remote control, or
use other remote control to pair with the camera again.
If one to one code matching failed, the red LED light flashes for 20 seconds and then goes
off, camera will stop code match and turn on sleep mode; Press any key to wake up the
camera and re-match code.
Note: After code matching successfully, please select the camera address to control it.
Clear Code:
Press the "set" and "#" keys combined for 3 seconds, LED indicator starts flashing.
Camera will power off and on, the LED indicator will go off if clear code successfully.
Sleep Mode and Wake Up:
Press any key to wake up the camera from sleep mode.
3.2.2 Keys Introduction for IR Remote Control
1) In this manual, “press the key” means a click rather than a long-press, and a special note will be given if a
long-press for more than one second is required.
2) When a key-combination is required, do it in sequence. For example,“
【
*
】
+
【
#
】
+
【
F1
】
”means
press“
【
*
】
”first and then press“
【
#
】
” and last press“
【
F1
】
”.
1. Standby Key
The camera enters standby mode if long press 3s on standby key;
Long press 3s again on the standby key, the camera will self-check again and return to HOME position (If
preset 0 position is set, the camera will return to preset 0 position).
2
.
Camera Selection
Select the camera address to control.
3. Focus Control
